بحث

بحث

مستشعر تدفق المياه DIGITEN G3/4 بوصة، مستشعر تدفق المياه بدرجة الطعام، عداد التدفق 1-60 لتر/الدقيقة - متوافق مع Arduino وRaspberry Pi ومرشح التناضح العكسي

KWD 5
ماركة
DIGITEN
وزن
61 g
مقاسطول الكابل 15 سم
– 1 +

مميزات خاصة

  • ☺Work for Arduino, Raspberry Pi, and Reverse Osmosis Filter. Small size, waterproof, easy to install, heat resistance, pressure resistance, cold resistance.
  • ☺Material: All materials align with ROHS testing standards, and can be used for potable water.
  • ☺Cable length: 15cm. Flow range:1-60L/min, working voltage range:DC 5-18 V, allow compression:Water pressure 1.75 Mpa below.
  • ☺Hall effect sensor. Connect to G3/4 inch BSP male thread, if used for NPT, need thread seal tape. Output waveform: square wave, output pulse signal.
  • ☺Wide application: It is mainly used in water heater, coffee machine, water purifier, drinking fountain, beverage machine, campus smart card equipment, etc.

وصف

Specifications:
Frequency: F=5.5 * Q (L / Min), error: ± 2%, current can not exceed 10mA, 330 pulses/liter. F=onstant * units of flow (L / min) * time (seconds).
Flow range:1-60L/min
Maximum current:10 mA(DC 5V)
Working voltage range:DC 5-18 V
Load capacity:≤10 mA(DC 5V)
Operating Temp: ≤80℃
Operating humidity: 35％ - 90%RH
Allow compression:Water pressure 1.75 Mpa below
Insulation resistance: >100M OHM
Storage Temperature:-25℃～80℃
Storage humidity:25%～95%RH
Output Waveform:Square Wave,output pulse singal.
Cable length:15cm.

Package include:
Flowmeter x 1

منتجات شبيهه

{"error":"\u062e\u0637\u0623","cart_limit":"\u0644\u062f\u064a\u0643 \u0627\u0644\u0643\u062b\u064a\u0631 \u0645\u0646 \u0627\u0644\u0645\u0646\u062a\u062c\u0627\u062a \u0641\u064a \u0633\u0644\u0629 \u0627\u0644\u062a\u0633\u0648\u0642 \u0627\u0644\u062e\u0627\u0635\u0629 \u0628\u0643.","prod_limit":"\u0644\u0627 \u064a\u0645\u0643\u0646\u0643 \u0625\u0636\u0627\u0641\u0629 \u0627\u0644\u0645\u0632\u064a\u062f \u0645\u0646 \u0647\u0630\u0627 \u0627\u0644\u0645\u0646\u062a\u062c"}