ELIMINATE GUESSWORK: Use the ABN | 28-Piece Transfer Punches Set 3/32-Inch to 17/32-Inch to remove the guesswork of where to place the center punch mark in a hole when transferring dead center from threaded, drilled, tapped, and reamed holes; For toolmakers, machinists, fabricators, and hobbyists to use on metal, wood, and other surfaces; Useful for a tool for die marker or repair, finding rifle stock screw and bolt hole locations, and even rock painting
PERFECT SIZES: 4-7/8-inch (12.4cm) length of each punch with 0.0025-inch undersize for easy use; Standard imperial SAE sizes include 3/32”, 7/64”, 1/8”, 9/64”, 5/32”, 11/64”, 3/16”, 13/64”, 7/32”, 15/64”, 1/4”, 17/64”, 9/32”, 19/64”, 5/16”, 21/64”, 11/32”, 23/64”, 3/8”, 25/64”, 13/32”, 27/64”, 7/16”, 29/64”, 15/32”, 31/64”, 1/2”, 17/32”
BUILT TO LAST: Constructed from heat-treated tempered steel with a black oxide finish for maximum strength and longevity that resists corrosion and prevents rounding, mushrooming, or chipping of the conically-shaped (cone) tips; Flat ends are slightly chamfered at the edge; We recommend using these pieces as transfer punches – not intended to take place of a center punch
EASY TO USE: Select one of the punches, hold punch shaft with one hand while gently tapping a hammer (not included) on the flat top of the punch to make a mark on your selected material that is visible for your center punch, then use your existing center punch (not included) to make a dimple
PACKAGE CONTENTS: Transfer punch sets package includes (28) transfer punches plus (3/32-inch to 1/2-inch diameters incremented by 1/64-inch, plus a 17/32-inch diameter punch) and (1) 5.25” x 2.5” x 1.6” inch (13.3cm x 6.4cm x 4.1cm) plastic index stand for easy storage (each slot is labeled with SAE sizes for quick identification)
