ESP32-C6-WROOM-1: ESP32-C6-WROOM-1 is a universal module that supports Wi Fi 6, Bluetooth 5, and IEEE 802.15.4 (Zigbee 3.0 and Thread). This module is equipped with ESP32-C6 chip, PCB board mounted antenna, and 8 MB SPI flash.
Pin Header: All available GPIO pins (except for the SPI bus of Flash) have been led out to the pin header of the development board.
5V to 3.3V LDO: power converter, input 5V, output 3.3V.
3.3 V Power On LED: This indicator light lights up when the development board is connected to a USB power source.
USB to UART Bridge: A single-chip USB to UART bridge that can provide transmission rates of up to 3 Mbps.
ESP32-C6 USB Type-C Port: The USB Type-C interface of the ESP32-C6 chip supports USB 2.0 full speed mode, with a maximum data transfer rate of 12 Mbps (note that this interface does not support 480 Mbps high-speed transfer mode).
Boot Button: Download button. Press and hold the Boot key while pressing the Reset key to enter the "firmware download" mode and download firmware through the serial port.
Reset Button: Reset button.
USB Type-C to UART Port: can be used as a power interface for development boards or as a communication interface, communicating with ESP32-C6 chips through an onboard USB to UART bridge. RGB LED: an addressable RGB light-emitting diode driven by GPO8.
J5: Used for measuring current.