1. Using a Single Load Cell 1x50kg by Adding 2 Resistors
-Connect outer wire(white and black) of load cell to E+ and E- outputs of hx711 module.
-Connect middle cable(red) of load cell to A+ input of hx711 module.
-Connect two 1k resistors to A- input of hx711 module. Then the other end of resistor to white and black wires.
-Connect GND of hx711 module to board GND, and VCC to board 5V pin.
-Connect DT and SCK of hx711 module to any digital IO pins of board.

2. Using Two Load Cells in a Singel Circuit 2x50kg (100kg)
-Connect opposite sides of outer wires(white and black) of two load cells.
-Connect outer wire pairs to E+ and E- output of hx711 module.
-Connect middle wire(red) of load cell to A+ and A- inputs of hx711 module.
-Connect GND of hx711 module to board GND, and VCC to board 5V pin.
-Connect DT and SCK of hx711 module to any digital IO pins of board.

3. Using 4 Load Cells in a Single circuit 4x50kg (200kg)
-Form a loop by linking same color outer wires(white and black) of the four load cells.
-Connect middle cable(red) of one of the diagonals to the E+ and E- outputs of the HX711 module.
-Connect the other diagonal to the A+ and A- inputs of the HX711 module.
-Connect GND and hx711 module to board GND, and VCC to board 5V pin.
-Connect DT and SCK of hx711 module to any digital IO pins of board.

Package Included:
8 x 50kg Half-bridge Load Cell
2 x HX711 AD Weight Module