Specifications:

Pulses: 600 p/r (Single-phase 600 pulses /R,Two phase 4 frequency doubling to 2400 pulses)
Power source: DC5-24V
Shaft: 6*13mm/0.23*0.51"
Size: 38*35.5mm/1.49*1.39"
Output: AB 2phase output rectangular orthogonal pulse circuit, the output for the NPN open collector output type
Maximum mechanical speed: 5000 R / min
Response frequency: 0-20KHz
Cable length: 1.5 meter
Fixed empty as: three 3mm screw holes distribution of 120 degrees / or six 3MM screw holes into 60 degree distribution,to the center distance of 14mm.
Wires length: 188cm / 74"

Notice:
AB 2phase output must not be directly connected with VCC, otherwise, will burn the output triode, because different batches, and may not have the terminal.(Green = A phase, white = B phase, red = Vcc power +, black = V0)

Output:
AB two -phase quadrature output rectangular pulse ,the circuit output is NPN open collector output type ,the output of this type can and with internal pull-up resistor is directly connected MCU or PLC ,such as 51 single or Mitsubishi PLC (PLC input mode should be connected to 0V switch function ).
Note: If the encoder is not connected to the device can not be directly oscilloscope oscilloscope ( open collector output without pull-up resistor when there is no voltage output ) If you want the oscilloscope in AB two-phase output with two pull-up resistors.

Package included:
1 x Encoder 600P/R Incremental Rotary Encoder