Hydraulic Valve Mounting Sub Plate Aluminum D03 NG6 Cetop 3 pattern SAE -8 Ports (1/2" nominal dimension port), SA6 Series

Clear anodized aluminum for superior surface finish, better paint adhesion and stain resistance.
Uses M5-.08 thread for valve mount. The use of 10-24 threads found with many US valves can allow unsafe orientation of valve due to the smaller diameter. Therefore a locating pin is often needed with the 10-24 thread. We prefer the correct M5 thread.
Standard SAE -8 3/4-16 O-ring ports for a leak free system.
3000 PSI maximum Pressure
Note that one of the threaded valve mounting holes is offset less than 1mm to prevent mounting the valve in the wrong directions. If all bolts do not fit rotate the valve 180 degress and try again.

Hello,