Description:
- SKD08 test clips are used for chips with spacing greater than 0.3mm. The method of holding small chip pin: Wobble the hand gently and push froard slightly.
- After use, don't force the clip off from the chip pin. To push out the clip and gently remove it from the chip pin.
- If it can't hold the chip pin, please refer to the picture: Adjust the front end of the clip with tweezers to make the angle close to 90 degrees.
- High performance and it is in great reliability, cause it has been through testing standards.
- Model: SDK08; Voltage: 40V; Current: 2A.

Specification:
- Size: 60x40x20mm

Package Includes:
10x Micro IC Clamp

Note:
Conversion: 1inch=2.54cm, 1cm=0.393inch
Please allow slightly 0-1cm difference due to manual measurement.
Colors can appear different depending on light and how the listing is viewed.
Thanks for your understanding and attention. Wish you a pleasant shopping experience!