Product Introduction:
The product is installed at the water inlet end of the water heater to detect the inflow flow. When the water passes through the water flow rotor assembly, the magnetic rotor rotates and the rotational speed changes with the flow. The Hall sensor outputs a corresponding pulse signal and feeds it back to the controller, which judges the magnitude of the water flow for regulation. Frequency: F=5 * Q (L/Min) - 3
Error: ± 2%
Voltage: 3.5-24VDC, current cannot exceed 10mA
Output 300 pulses after flowing a liter of water
Output waveform: square wave (NPN signal)
Range: 1-30L
Pin Description:
Red: IN connected to positive electrode
Yellow: OUT signal output line
Black: GND connected to negative electrode
matters needing attention:
Severe impact and chemical erosion are strictly prohibited.
It is strictly prohibited to throw or collide.
The medium temperature should not exceed 100 degrees.
The current used shall not exceed 10mA.