Relay Board Maximum Load: AC 250V/10A; DC 30V/10A With Power and Relay Action Indicator;Trigger Current: 5mA
Jumper Design: The Relay Module has a Jumper That You Can Set Rather the Unit State Changes with High or Low Signal. Has Screw Terminals for Relay (NC,C,NO) and for Input; Coil +, Coil - and Trigger.
Optocoupler Isolation:1 Channel Relay Board use Optocoupler Isolation that has Strong Driving Ability and Stable Performance ,The Isolation Circuit Prevent Damages to I / O Port by Relay Switch Current
Fault Tolerant Design, Even if the Control Line is Broken, the Relay will not Operate;All Interfaces of Relay can be Wired Out Through the Terminals Directly,Normally Open and Normally Closed
Easy to Install:Equipped with a Terminal Block and Fixed Bolt Holes on Both Sides (Diameter: 3.1mm), the Interface can be connected through the terminal block directly Wide Application:Standard Interface can be Connected with Microcontrollers Directly ,The Relay Module Can be Used to Control Various Loads, such as Electromagnetic Relays, LED Lights,Drivers, Motors, Electric Motors, Straws, etc.
Baomain Magnetic Starter HUEB-16K On Off Switch Enclosed 3 Pole 110V Coil 12.5-18A
KWD 15
Current Sensing Switch, Normally Open Current Sensing Switch Adjustable AC 0.2-30A SZC23-NO-AL-CH
KWD 6
DIANN 8 Channel Relay Module DC 12V Relay Expansion Plate Load Controlled Relay Switch Module
KWD 3.500
Gardner Bender GSW-69 Electrical Rotary Switch, SPST, ON-OFF, 6 A/125V AC, 6 inch Wire Terminal, Black Plastic
KWD 3
