Specifications:
Type: Filament Connector
Diameter: 1.75mm
Overall Size: 45x40x12mm
Material: Aluminum
Colour: Black,Silver
p>How to Use :1.Cut the Filament Head by Hand
2.Apply the Filament to Both Ends of the Connector
3.Heat the Filament to Soften
4.Slide the Filament Into the Hole and Then Squeeze and Pull it Several Times
5.Remove the Filament and Cut Off the Connection
Note:
1.About The Filament, More Used, More Bending and More Rebound,Therefore,It is Stabilized With Finger Before Fire, Which Can Increase the Success Rate
2.Burning Time of the Filament Depends on the Harder of the Material,Harder Material Longer the Burning Time
3.Do Not Wait Until the End of the Filament is Very Close to the Extruder
4.When Using, Push From the Small End to the Big End
Package Contents:
1x Filament Welder Connector (Black)
1x Wrench