Product Parameter
Size：12mm OD
Shape: T Shape
Material: Plastic
Working Temperature:32～140°F
Fluid Admitted: Air
Max Working Pressure: 0~145Psi
Applicable Tube:PU/PA/FEP/PFA

Installation Method
1. Before installation, make sure that the cutting surface of the tubing is vertical, there is no scar around the tube and the tube is not oval.
2. When inserting the connector, it must be inserted at the bottom of the connector. If the tube is not inserted in the end, it may cause air leakage.
3: After the tube is connected and installed, pull the tube to make sure that the tube cannot be pulled out.
4: When removing the air tube, press the connector clamp into the tube with thumb, and gently pull out the pneumatic tube with force
5: After installation, The Tube Can Rotate 360° to adjust the connector direction.
6: After repeatedly pulling out the pneumatic tube.The top frayed part should be cut off.Continue to use after trim.