You know how easy it is to overdrive a screw and drive it too deep, especially when working with MDF or particleboard! PowerHead Screw's unique design completely eliminates this problem while offering two installation options! Above the surface: Drill the PowerHead into position so that the entire head sits on the surface of your material. Below the surface: In combination with an impact driver drill, the PowerHead Screw has been engineered with nibs underneath the large 9/16" head to cut through your material and allow your screw to sit perfectly flush with the material surface. The type 17, self-drilling auger point allows these screws to be driven into most woods without a pilot hole, and wide threads provide greater holding power. #8 gauge; zinc plated; 9 TPI.
Developed by Fastcap specifically for installing cabinets, these screws can be used with or without our peel and stick cover caps. The Powerhead screws feature an auger tip for faster starting, and cutting nibs on the bottom of our flat head for perfectly seating the screw flush with the surface. The 9/16" head size eliminates pull through and can be capped off by a variety of cover cap options, also available from Fastcap. Screws have a #2 square drive recess, a #8 size shank, and are available in a variety of pack sizes in both 2.5" and 3" lengths.