Search

Search

UP to 450C PT1000 Thermistor Cartridge High Temperature Sensor for 3D Printer Volcano V6 Heater Block Hotend PEEK PEI Printing

KWD 6
Brand
POLISI3D
Weight
18 g
– 1 +

Special Features

  • Thermistor Cartrodge PT1000 Used for many heater block which has 3.1mm temperature thermistor hole like v6 hotend Volcano Hotend Maximum support to 450 degrees.
  • PT1000 sensors are able to measure higher temperatures than thermistors - up to 450°C,and are more accurate then both thermistors and thermocouples in general. About the firmware setting, please check this forum: https://github.com/POLISI3D/PT1000-thermistor-cartridge
  • PT1000 sensors can direct replace the thermistors in your printer without adding an amplifier board like PT100's sensors. but whith the default 4.7K pullup resister on board you will get lower resolution than other sensors.
  • PT1000 sensors are compatible with most firmwares in the field. PT1000 sensors are potentially a good cost and performance compromise between thermistors and PT100 sensors. If you want release potential abilities of the PT1000 sensors,you need to replace the 4.7Kpullup resister of the thermistor pins with a 1K 0.1% resister.
  • Package: 1 x 1meter length PT1000 seneor with sealed with metal cartridge ; 4 x 1K 0.1% SMD Resistors 0603 package; and 1 x 2P 2.54MM Terminal wire

Description

Operating temperature range 0-450 degrees; Metal cartridge dimension 3MM diameter 15MM length; Lead 1Meter length fiberglass High temperature resistant wire.

Related Items

{"error":"Error","cart_limit":"You have too many items in your cart.","prod_limit":"You cannot add any more of this item"}