DEVMO 2PCS Heat Bed Mosfet,3D Printer Heat Bed Power Module 3D Printer Board Expansion Board 25A MOS Tube High Current Load Module

WELL MADE- New material with superior quality stainless, High-grade Aluminum block for best connectivity and long life.
HIGH TRANSMISSION - With this addon module to your 3D printer motherboard you can lead the maximum current up to 25A.
MULTIFUNCTION - Completely solve the hot bed power is too large and load current problems,and can well protect the connectors on the controller board from overheating.
MEET YOUR NEEDS -Widely used for common 3D printer models,extruder and other open 3D printer motherboards.such as Anet A8, etc.
WARNING - For use on some devices (for example,Anet A8),you need to make sure the power supply is set to 110 volts instead of the default 220 volts.If the voltage is too high, the product will get super hot, even charred!! Don't touch it lightly.

Product Description:

Heated bed power module

Based on powerful MOSFET HA210NO6

Size: 60*50mm

Mounting holes: 3.2mm diameter, for M3 screws.

Distance betweeen holes: 54*43mm

Very powerful MOSFET to withstand higher current than normal RAMPS or other 3D Printer controller can handle

Voltage: 12V-24V

Maximum current with active cooling: 210A

This module is based on power MOSFET and will allow PID control of the heated bed (DC-DC Relays usually do not allow this)

Under the premise of normal cooling, it work stable under I(Max)=25A, the current must not exceed 25A while the process working

Package Includes:

1 x Heated Bed Power Module

1 x Connection cable for input signal

Hello,