Specification:

Sealing Material: Special Rubber

Driver Base Material: Die-Cast Aluminum

Driver Cover Material: Flame Retardant ABS Engineering Plastics

Driver Motor: Hysteresis Synchronous Motor

Power Consumption: 7.5VA

Valve Body Pressure: 1.6Mpa

Allowable Pressure: 0.13Mpa

Applicable Medium: Cold Water, Hot Water

Applicable Medium Temperature: 2-95

Applicable Environment Temperature: 0-60

Open Time: About 10 seconds

Close Time: About 5 seconds

Valve Connection Mode: G1/2

Weight: Approx. 517g / 18.2oz

Height: Approx. 12cm / 4.7in

Diameter: Approx. 2cm / 0.8in

Package List:

1 x Motorized Ball Valve

Installation and Commissioning:

1. Before the installation must carefully read the instructions, cut off the power and must be installed by professionals.

2. Flow direction must be the same as the direction of the arrow on the valve body.

3. The valve body must be located above the fan water tray, to ensure that the drip drop into the water tray.

4. Valve body and driver must be installed in the vertical direction ±60° range, it should have at least 30mm space above.

5. The building must maintain enough maintenance operation space, and must be installed in the maintenance that repairing person can reach.

6. Two and more than two of the electric valve can not be parallel, if the need for parallel relays to be separated.

Note:
Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.