Instructions

1.After receiving the module, do not install the module to the printer. First connect the signal wires of the module to the motherboard one by one.

After power on, there will be a needle suction and push needle action, which is normal.

2.When the main board and the module are powered on, do not plug and unplug the cables casually.Please be sure to connect when the power is off.

3.After the firmware setting is completed, it is still uncertain whether the setting is correct. You can manually trigger the module in advance to check whether the machine is operating normally.

4.If it is abnormal, please stop it in time and recheck the firmware settings.Prevent the probe from hitting the platform, causing damage to the module.

5.Due to there are too many motherboard manufacturers and models, advise customers to consult the motherboard manufacturer for specific settings.To prevent incorrect settings due to different motherboards.

3D Touch parameters :
Voltage： 5V
Current：15mA
Max current(peak)：300mA
Shell material：PC
Shell color：White translucent
Cable length:short:200mm Long: 1000mm

Wire:
3pin: Green:- GND
Red: +5V
Wire Orange: Signal cable
2pin: Black:,GND
White: Zmin

Shipping list：
1pcs x sensor
M3 nut/screw
1pcs x 200mm cable
1pcs x 1000mm cable
Coiling terminal
XH2.54mm 3 pin terminal
XH2.54mm 2 pin terminal