Twist Guard test leads offer adjustable length test tips for use in different measurement environments. Includes removable 4mm lantern tips that thread onto the lead tip. Fluke TL175 are the only test leads as tough as your meter. Patented TwistGuard extendable tip shroud meets the highest electrical safety requirements to reduce tip exposure while providing the versatility needed for most measurements. New WearGuard lead wire wear indication. Each test lead is covered by two layers of silicone insulation; inner contrasting color is exposed when the leads are nicked, scuffed, or otherwise damaged and in need of replacement. Double Insulated Silicone leads. TL175 test leads withstand high temperatures and remain flexible in cold temperatures. Extra-heavy duty strain relief on both probe-end and plug-end, tested beyond 30,000 bends without failure. Universal input plugs are compatible with all instruments that accept standard 4mm shrouded banana plugs. Probes always show correct category rating for tip being used. Exposed probe tip length: 19mm to 4mm (0.75" to 0.16"). Ratings: CAT II 1000V, CAT III 1000V, CAT IV 600V, 10A maximum, Pollution Degree 2. Environmental ratings: -20 to 55 degree C (-4 to 131 degree F), altitude: 2000m (6,562'). Conforms to EN61010-031. 1 year warranty.
The Fluke TL26A 5-Way Test Lead Set gives you five ways to connect to terminals. The u-shaped nose set is designed for blade-shaped terminals and the notched jaw set is for gripping screw heads, bare wire or terminals. The leads with serrated teeth are for gripping threaded or wire-wrapped terminals and the leads with a cluster of sharp needles are for piercing small gauge (no. 22 and 28 AWG) wires. The set with a large piercing needle is for penetrating larger gauge wires. The 60-Inch (1.5m), silicone-insulated leads are useable from -112 to 302 Degree Fahrenheit (-80 to 150 Degree Celsius). They are rated for 30V, 10A. The Fluke TL26A 5-Way Test Lead Set is sold as one set per package. Expand your testing capability or update your tools with test lead sets and kits. Designed for industrial, electrical, and electronic needs, the collections range from starter to master test lead selections. Because they are an integral part of the complete measurement system, worn or under-rated test leads can cause inaccurate readings and pose a serious shock or electrocution hazard if live wires are read as being de-energized. To avoid these risks, use the correct test probe for the application. Test leads are replaced on average every 18 months.