DC Motor

Operating Voltage: 3V ~ 6V DC

Reduction ratio: 1:48

When the voltage is 6V:

No-load current: ≤200mA

No-load speed: 200±10%rpm

When the voltage 3V:

No-load current: ≤150mA

No-load speed: 90±10%rpm

Used for electronic fans, electronic machinery, toys, cars, robots, arduino projects, etc.

L298N Motor Drive Controller Board

Module name : dual H bridge motor drive module

Work mode : H bridge drive (double road)

Main control chip : ST L298N dual H-bridge driver chip

Logical voltage : 5V

Drive voltage : 5v-35v

Logical current : 0mA-36mA

Driving current : 2A(MAX single bridge)

Storage temperature : - 20 ℃ to + 135 ℃

Maximum power : 25W

Notes:
General Application: When your driver is 7V-12V, you can enable the on-board 5V logic supply.
When using the on-board 5V power supply, the + 5V power supply in the interface does not input voltage, but it can draw 5V voltage for external use.
Unconventional application of high-voltage drive: When the driving voltage is higher than 12V, less than or equal to 24V, for example, to drive a motor with rated voltage of 18V, the jumper cap with 5V output enabled on-board voltage must be pulled out and then outside the 5V output port Connect 5V voltage to L298N internal logic voltage supply.

Product List:
4 x Smart Car Wheel
4 x DC Motor
2 x L298N Motor Drive Controller Board
20 x 20CM Jumer Wire female to female
20 x 20CM Jumer Wire Male to Male
20 x 20CM Jumer Wire Male to Female