Features:
1. Onboard high-performance microcontrollers chip;
2. Onboard CH340 USB control chip;
3. Onboard power LED and relay status LED;
4. Onboard 2-way 5V, 10A / 250VAC, 10A / 30VDC relays, relay life can be a continuous pull 10 million times;
5. Module with overcurrent protection and relay diode freewheeling protection;

Hardware introduction and description
Board size: 50 x 40mm
Board Interface Description:
COM1: common;
NC1: normally closed;
NO1: normally open.
COM2: common;
NC2: normally closed;
NO2: normally open.

Communication protocol description:
LC USB switch default communication baud rate: 9600BPS
Open the first USB switch: A0 01 01 A2
Turn off the first USB switch: A0 01 00 A1
Open the second USB switch: A0 02 01 A3
Turn off the second USB switch: A0 02 00 A2

USB switch communication protocol
Data (1) --- start flag (default is 0xA0)
Data (2) --- switch address codes (0x01 and 0x02 represent the first and second switches, respectively)
Data (3) --- operating data (0x00 is "off", 0x01 is "on")
Data (4) --- check code

Relay status query command:
Send "FF" as hexadecimal (hex) to query.
For example, if relays 1 and 2 are ON, and relays 3 and 4 are OFF, sending the relay query command "FF"will return:
"CH1:ON \r\nCH2:ON \r\nCH3: OFF\r\nCH4:OFF\r\n"
(Each channel relay is to return 10 byte sequence information)

Usage Description:
1. Connect the USB relay module to the computer and install the CH340 USB to serial chip driver
2. Open the STC-ISP, SSCOM32 such serial debugging software, select the baud rate of 9600, in hexadecimal (hex) form send A0 01 01 A2 and A0 02 01 A3 can be opened the first and second relay ; Send in hexadecimal (hex) A0 01 00 A1 and A0 02 00 A2 can be turned off the first and second relay, respectively.

Package Included:
1pcs NOYITO 5V2-Channel Micro USB Relay Module