Search

Search

6pcs L298N Motor Driver Controller Board Module DC Stepper Motor Dual H-Bridge for Arduino

KWD 5.500
Brand
XIITIA
Weight
5 g
All electronics ship with US style plugs. You may need a voltage converter or a plug adapter.
– 1 +

Special Features

  • ★High working power to 35v,large current can reach 3A MAX and continue current is 2A, power to 25w.
  • ★To avoid damage the voltage stabilizing chip, please use an external 5V logic supply when using more than 12V driving voltage.
  • ★L298N as main driver chip makes strong driving ability/small heating/strong anti-interference/low calorific value.
  • ★Use large-capacity filter capacitors and diode with freewheeling protection function, increasing reliability.
  • ★Dual-channel H-bridge driver working mode creates higher working efficiency,L298N as main chip.Can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors.

Description

Specification:
Chip: ST L298N dual H-bridge driver chip
Logic Voltage: 5V
Logic current 0mA-36mA
Storage Temperature: -20 ¡æ to +135 ¡æ
Operating Mode: H-bridge driver (dual)
Drive Voltage: 5V-35V
Drive Current: 2A (MAX single bridge)
Maximum Power: 25W
Driver Board Size：55mm*60mm*30mm
Driver Board Weight:33g
Dimensions: 43x43x27mm

Note:
When your driver is 7V-12V, you can enable the on-board 5V logic supply. When using the on-board 5V power supply, the + 5V power supply in the interface does not input voltage, but it can draw 5V voltage for external use.

When the driving voltage is higher than 12V, less than or equal to 24V, for example, to drive a motor with rated voltage of 18V, the jumper cap with 5V output enabled on-board voltage must be pulled out and then outside the 5V output port Connect 5V voltage to L298N internal logic voltage supply.

Related Items

{"error":"Error","cart_limit":"You have too many items in your cart.","prod_limit":"You cannot add any more of this item"}