Self-Programmable Remote Car Key Replacement

An inexpensive replacement for your original remote key fob, the car key replacement is self-programmable and comes
with easy do-it-yourself instructions to help you program your new car key at home. Each fob key has been pre-tested to
ensure functionality and that signals are transmitting proper.

How to Program your Remote Key Replacement:

1. Close and lock all doors with the driver's side power lock switch located on drivers door panel.
2. Insert key into ignition (DON'T TURN) and remove it from the ignition key cylinder at least 6 times within 10 seconds
(this will need to be done at approximately one second intervals). You may need to insert and remove the key up to 10
or 12 times until your hazard lamps flash. PLEASE NOTE: Withdraw key completely from ignition cylinder each time. If
this procedure is performed too fast or too slow the system will not enter programming mode.
3. Insert key into ignition and turn to the ACC position.
4. Within 5 seconds, push the LOCK button on the keyless remote. Your hazard lamps will flash. PLEASE NOTE: Do not
press the button on the remote more than one time or the programming will not be successful.
5. If there are any remaining remotes (including working ones), Unlock then Lock all doors using the switch on drivers door
panel. Within 5 seconds of locking and unlocking doors press LOCK button on the next remote. Your hazard lamps will flash.
Repeat this step for each remote (including any working remotes).
6. When all remotes have been programmed turn the key to the OFF position, remove keys from the ignition, unlock doors
using the driver's side power lock/unlock switch and open the driver side door. Test all remotes.

Note: You must have all remotes on hand when performing this procedure. Any remotes not used during this procedure will become inactive.