Weed & Cut:
1. All designs must be cut in reverse.
2.Craft Cutter Setting: -For Cricut: Blade: Standard; Setting: Iron-On *Settings may vary based on blade condition and age of the machine.
3. Weed out the excess material.

Heat and Transfer
Place the sheet with your design on to your shirt and place the Teflon sheet on the top of your design.

Home Iron:
-Please Heat the iron on medium setting (302°F– 320°F);
-Press each section of the design with medium/firm pressure for 10-15 seconds;

Heat Press:
-Preheat garment for 2-3 seconds;
-Apply design at 305℉;
-Use medium pressure for 10-15 seconds;

Cool Peel:
Peeling the clear pet film after the vinyl turns cold, just in 15-30 seconds later for the vinyl to cool down.

Note:
If any part of the iron on vinyl lifts off, repeat the steps above until you can peel off the clear backing without lifting up the vinyl.