Note: Unplug the white plastic sheet on the back of the skateboard, turn on the power, flip the switch, and the skateboard will glow!

Novice teaching:
1. How to "Stand" on the Finger Skateboard 2
1. The middle finger is placed on the end of the finger slide.
2. The index finger is placed on the middle and upper position of the finger skateboard (about three-quarters of the board body)
Notice:
1. The middle finger and index finger should not exceed the edge of the finger skateboard.
2. The position where the middle finger is placed is the tail of the board, and the other side is the head of the board
2. Dolphin jump
1. The forefinger and middle finger "stand" so that the skateboard stops.
2. The index finger is slightly relaxed, and the middle finger hits the tail of the (bed) board downwards, so that the board body and the desktop are at 75-90 degrees.
3. When the board body is 75 degrees to 90 degrees with the desktop, the middle finger stabilizes the skateboard, and the index finger slightly pushes the skateboard forward from left to right, and then
After landing.
3. The ultimate dolphin jump
1. Start with dolphin jumping.
2. The vertical height of the dolphin jump is higher than 25cm, and the horizontal distance is greater than 30cm.
4. Earth Spin 180
1. The index and middle fingers "stand" on the skateboard.
2. With the middle finger, press down the tail of the board lightly and forcefully, and at the same time move it inward. Make the skateboard a half turn clockwise (180 degrees).