2-8s XT60 Parallel charging board:It can used with 6S,8S,10S balance chargers of XT60 main charge port or Banana port.
Specification:
Connector: 6 XT60;
Max current: 40A
Output charge :12AWG silicon cable
Cell: 2~8S
Battery: 6 packs (same discharge state and amp; cell count)
Voltage: 0~33.6VDC
USE STEPS
1. Connect the both sides of a balance cable respectively to the balance port of the balance charger and parallel charging board.
2. Connect the power port of Parallel charging board to the output port of balance charger.
3. Connect batteries to the board. Plug the balance heads firstly, and then connect them to the batteries' outputs.
NOTE
The max-current of this parallel charging voltage must be the same .
and the capacity and cells of batteries should be the same if charge at the same time.
Not matter the discharging rate.
After several single cell balanced ，the voltage wil be more balanced and the voltage gap will be smaller .
Features:
Used for simultaneously charging multiple lithium batteries(including LiPo,LiHv,LiFe, and Li-ion types) in parallel .
Convenient to charge and balance up to six lithium batteries at the same time when used with a balance charger .
The charging time is significantly reduced since all batteries are balanced at the same time instead of balancing batteries one by one .
Built-in short circuit protection,With 40A fuse for main charge channel and with 1.1A fuse of balance channels.
Package Includes:
1 x 2-8s Parallel charging board
1 x 8S Balance Cable
1 x 10S to 8S Balance Cable
1 x 10S to 6S Balance Cable
1 x XT60 male plug to Banana apdater cable
-------------------------------------------------