✡How to Make a Resin Mold:
1. Pour resin into measurement cup, slowly stir to release bubbles. Adding glitter or pigment into it if you need.
2. Pour it into your mold and slowly stir. Allow to stand for 24 hours and take it out.

✡How to De-mold:
Usually, most of the resin pieces could pops out from the mold easily.
There are 2 methods to make this process easier.
1. Use mold release to keep the resin from sticking to molds, and it is great for prolonging the life of molds.
2.After your resin pieces are completely cured, pour some soapy water into the mold.

✡How to Clean and Store Silicone Molds:
1.You can wash it with warm water and soap or rubbing alcohol,  then use a soft cloth to wipe clean. Clean the mold after each use to maintain gloss and extend mold life.
2.Please store the resin silicone molds away from direct sunlight and dust.

✡WARM NOTE:
These resin molds are only for casting resin,not for coating resin.
Don't use a torch and heat gun to pop bubbles while resin in the molds,it will damage the molds.

✡Package Included
2pcs x 8inch (20.32cm) Display Stand Resin Mold