BAYCK ELRS915M-NANO ExpressLRS Long Range Lower Latency Receiver for FPV Racing Quadcopter Drone(ELRS915M-NANO)

1)The BACKY ELRS 915M-Nano receivers is an open-source program Based on ExpressLRS, we have 4types RX modules are Released. All of the receivers use the ESP8285MCU.Your Firmware can be upgraded via WIFI, which is more easier
2) Lowe Latency and High refresh rate, they are very suitable for FPV racing and long range FPV cruising while being ultra-light and ultra-small which made the installation easier.
3) Usually when you just supplied the power or do not turn on the remote control, the ExpressLRS can be found hot after 60s by default, then the receiver will get in the WIFI automatically, the LED flashing .
4) The BACKY ELRS 915M-Nano Receivers is an open-source program based on ExpressLRS,, so any ELRS 915MHz receivers can work with any ELRS 915MHz TX modules , from any manufacture and even DIY ones, this is as long as they have the same binding phase and configuration options( Regulatory Domin, Performance options and Extra Data)
5)weight: 0.6g （without antenna）, if very tiny for the drone. Optimized PCB design for better dissipation

Item: ELRS 915M-NANO

Frequency: 915MHz(AU,EU Update Firmware)

Chip: ESP8285MCU

RF CHIP: SX1276

Telemetry Power: 20dbm

Maximum Receive Refresh Rate：500HZ

Minimum Receiver refresh rate: 25Hz

Working Voltage: 3.6V-5V

Weight : 0.6g(receiver only )

Work Protocol： CRSF（ Betaflight）

Dimension: 11mmx18mmx3mm

Antenna Connector: IPEX MHF

Firmware: BETAFPV 900RX