Matters needing attention:
1. Due to the use temperature of this product being 150-180 ° C, the operating temperature should not exceed 180 ° C for a long time
to avoid causing gum cracking and reducing the viscosity of the adhesive.
2. The amount of glue in the glue pot should be added according to actual use. Adding too much glue can cause the glue particles to melt multiple times,
which can cause them to deteriorate, age, reduce viscosity, and affect adhesion.
3. Please store in a cool, dry and ventilated place, avoiding direct sunlight, as the opening and curing time may vary depending on the adhesive temperature
and ambient temperature, coating amount, bonding time, and bonding pressure.
4. Due to the high temperature of the glue during heating, please do not touch it directly with your hands. If necessary, please wear gloves and protective clothing to prevent burns.

Operation tips:
1. Always use a thermometer to measure the actual temperature of Hot-melt adhesive on the roller.
2. In order to avoid thermal degradation of the product, the temperature of the adhesive groove should be appropriately reduced during work intervals.
3. If the temperature of the wheel is too low, it will cause low adhesion.

Recommended operating conditions:
Roller temperature: 180 ° c-210 ° c
Feed speed: ≥ 20m/min
Rubber tank temperature: 170 ° c-190 ° c
Base material moisture content: 8-10%
Pressure value: 3-5 kg/cm²
Substrate temperature: ≥ 15 ° C

Storage method:
Store in a dry and cool place below 40 ° C for a period of 2 years.

Product parameters：
Weight：11 Lb
Softening point: 80士5°C
Service temperature: 150-180℃
Viscosity value: 9000- 12000/cps