Feature:
1. Signal sided self-adhesive sticker, easy adhesion and simple to use.
2. Thickened stickers, bright color, non-reflective, waterproof, no fading.
3. Provide a simple and efficient background design for your aquarium with an attractive theme.
4. Made of high quality PVC material, non-toxic, no odor, no water stains.
5. A DIY sticker that allows you to cut it to fit the size of your tank.

Spec:

Item Type: Sticker
Condition: 100% Brand New
Color: As Shown
Material: PVC
Size: 61 x 30cm / 61 x 40cm / 76 x 46cm / 91 x 50cm / 122 x 46cm (Optional)
Size 1: Approx. 61 x 30cm / 24.0 x 11.8in
Size 2: Approx. 61 x 40cm / 24.0 x 15.7in
Size 3: Approx. 76 x 46cm / 29.9 x 18.1in
Size 4: Approx. 91 x 50cm / 35.8 x 19.7in
Size 5: Approx. 122 x 46cm / 48.0 x 18.1in

Paste Method:
1. Wipe the glass surface on the back of the aquarium, add a little detergent to the water (to reduce the viscosity of the glue), spray on the glass surface (do not spray a lot), or wipe with a damp cloth.
2. Peel off the corner of the background protective film, start to paste after aligning the fixed position, and apply even force slowly when pasting. If there is air bubble when sticking, you can tear it to the bubble and spray it again to re-stick and scrape. Do not slip in the order, the leaked area is easy to foam, and the bubble will not appear (4).
3. After affixing, use a squeegee or touch to check for any bubbles that are scratched. If there are bubbles, you can use a needle to open the bubble and squeeze it with a squeegee.
4. After the paste is finished, if the water is not scraped clean, the glue will turn white, peel off and blow dry with a hair dryer, and continue to stick flat.

Package List:
1 x Fish Tank Sticker

Q&A

Question:what size would i need for a 40 gallon tank?
Answer:I have this one on a 55 gallon tank so it would fit a 40. Just trim a bit off

Question:Would I be able to put it in the dryer to get the creases out? Thanks!
Answer:You could deal with these ways
1) Roll it up tightly with a cylinder for 3-5 days, it will be ok.
2) Heat it with a steam iron on the back of item, then it will be smooth.
3) Stretch it and clamp it to a back drop stand for 3-4 days, it also works.