The HSS-PointTeQ Fast Steel Metal Drill Bit delivers high speed drilling due to its tip design with Bosch technology. Its centering tip (Split Point) does not require pre-drilling or initial punching allowing quick and easy drilling start preventing material deviations. With fast perforations the HSS-PointTeQ Drill creates less heat and therefore less wear which brings high yield and higher number of perforations to the end of its life compared to competitors. The Drill has a high-elasticity body that decreases the risk of breakage, and has black oxide in its spiral making it easy to exit chips quickly. With exclusive Bosch technology, the HSS-PointTeQ Drill Bit is manufactured with forged body and machined tip providing high drilling yield until the end of its lifespan, but at an affordable consumer cost. This drill bit is suitable for drilling on ferrous and non-ferrous metals, steel alloys, steel sheets, steel tubes, cast iron, pure steel, cast steel, brass, brass, PVC, plastics and polyamide and suitable for use in drills, screwdrivers, column drills and bench drills. The HSS-PointTeQ Metal Drill Bit features a full portfolio with measurements in millimeters and inches ranging from 1mm to 20mm and from 1/16" to 1/2". It has a cylindrical fit in the same diameter as the drill and between measurements 10.5mm and 20mm has a reduced fitt/shank allowing for use in drills and screwdrivers with chuck up to 13mm. It is manufactured according to DIN 338, is N type (spiral angle) and has the tip at 135 degrees.