Surprise your loved one with this Tesla Replica Desktop supercharger! Designed based on the actual supercharging stations around the world. **CORD IS NOT INCLUDED WITH PURCHASE*** This supercharger has been scaled up so that it can fit micro-USB, USB-C, and Lightning cables.  Step 1 Insert your cable through the base of the supercharger as shown. Step 2 Insert the charging cable through the hole in the red piece as shown. Step 3 With the cord inserted through the red piece, insert and press the red piece into the backside of the white piece (the one that has the space for the charging cable cord. Step 4 Lay the charging cable cord on the white piece as shown. Step 5 Fit the top white piece over the bottom white piece as shown. Ensure that the charging cable is not pinched anywhere. Step 6 Fit the 2 side pieces as well as the bottom piece into place and snap-fit everything. At this point, you can glue the pieces together if you are happy with the fit and placement of the charging cable cord. This item is made out of bio-friendly PLA (Polylactic Acid) plastic and is accomplished by printing plastic layer by layer, very slowly. PLA is considered the most 'earth-friendly' plastic since it is 100% biodegradable and not toxic. This item is printed in multiple pieces and assembled. *Please note all 3D printed items are unique and no two products are the same. The surface will not be perfectly smooth as you can see the layers of the object and there might be little bumps here and there as this is a property of this type of 3D printing. The color of the item may vary slightly from the display picture due to the filament supplier. --Disclaimer-- **This is not an officially licensed product and is only considered FAN ART, the item was modeled and remixed.