Max voltage: 15V
Max current: 24A
Relay setup: Dual relay
Speed: Single speed - 10 sec. delay to start up the second fan
Applications: Suitable for single and dual fan applications
Temperature Display: LED digital temp display actual temp + set temp
Temp Display: Centigrade+ Fahrenheit
Temp settings: 40°c to 110°c (104°F to 230°F)
Temp setting: Push Button
Circuit type: Pre-programmed micro controller
Output wires: Batt + Batt - IGN, AC Clutch, Fan #1, Fan #2 Thermistor Probe

This Digital Thermatic Fan Switch Kit can be used with Thermatic Fans and EWP's Fans. It senses air temperature as it passes through the radiator with the sensor placed in the radiator fin section so no need to cut hoses. It has an adjustable temperature range of 40ºC to 110ºC (104ºF to 230ºF) and can show Centigrade or Fahrenheit. Temp is set by pressing the set button. It operated thermally & also when the air conditioning is in operation.

The fans will operate until the air temperature is reduced by 1 degrees (C) from the set temperature.
To convert temperature reading from Centigrade to Fahrenheit, simply remove the plastic cover from the Jumper Pins by hand located below the LED screen.

IP66 Rated:
Protected from total dust ingress
Protected from high pressure water jets from any direction, limited ingress protection

24 Volt Application
Kit sold in 12-volt configuration, for 24-volt application, you will need to purchase 2 x 24-volt relays.