When your neck seal wares out your suit will leak like a sieve, a dry-suit is supposed to keep you dry, not get you wet. This neck seal, which is Trim-able to accommodate your neck size, can bring new and longer life to you dry-suit. The neck seal is made from durable Latex rubber for strength and durability. Neck seal can be used as a replacement for a damaged or worn Latex seal or to switch from a neoprene seal to latex.
TECHNICAL SPECIFICATION
Latex
Bellow shape
Guide ribs for easy trimming
Enhanced strength compared to Silicone Seals
Fits the Neck Tite system
Quick and easy replacement
Latex neck seals for use in the manufacturing and repair drysuits,diving suits, wet suits and other marine and industrial applications that specify resistance to salt water, oil and fuels etc.
Directions
1. Cut off the damaged seal, leaving the part of the suit where the factory seal is attached to the fabric. The new seal will be glued over the old factory seal edge.
2. Slide the new seal into the factory edge and put an elastic band or bungee around the suit to keep it in place.
3. Clean the edge of the suit and the new seal edge. Do not let the seal stick out too far, as the small end of the seal should not be stretched over it. It might cause the new seal to slide out of position.
4. Slide the seal on over the factory rubber area.
5. Roll back the new seal so that the 1inch edge that was over the old suit is now facing up. Apply a thin layer of Aquaseal Contact Adhesive to each side. Wait 5 minutes and apply a second layer of adhesive to each side. Use a spatula to apply the glue. When the glue is touch dry, roll the new latex seal right into place over the rubber part of the old seal. It bonds instantly. Press firmly over the glue area to ensure full adhesion