Universal 19 pieces hub & bearing puller

Comprehensive set for the removal and installation of front hub bearings

No dismantle of steering assembly needed

Heavy duty steel drifts

Not compatible for 2011 Honda Accord V6 3.5L Including multiple sizes of drifts, and the kit can be used for different models.

PACKAGE INCLUDES:
1 x Steel Drifts: 38mm;
2 x Drift: 86mm, 91mm;
1 x Receiver Sleeve: 76mm;
3 x Hub Screw: M12 x 1.5 mm;
3 x Hub Screw: M14 x 1.5 mm;
9 x Adapter Drift: 55.5mm, 59mm, 62mm, 65mm, 66mm, 71.5mm, 73mm, 78mm, 84mm.

Operation as reference:
1. Please check if the vehicle has a trapped rotor or a floating rotor.
2 .Assemble the tool components,then press out the worn bearing.
3. Lightly oil the new bearing and position it for installation with the tool components assembled. Press the bearing into the spindle assembly until it bottoms.
4. Fasten the bearing retainer in right place by using the bearing retainer bolts. (On Neon vehicles, install the snap ring in the knuckle.)
5. Assemble the tool components. Lightly lubricate the hub assembly, and install the hub.
Noted​: The bearing installer must be assembled with the flat side toward the bearing and the small diameter pilot on the side away from the bearing. 6. Assemble the remaining vehicle components that were removed for replaces the bearing:
1) lower ball joint to steering knuckle assembly brake rotor.
2) disc brake caliper.
3) outer tie rod nut and tie rod.
4) axle nut.
5) front tires.

If there is any quality problem about the product, please kinldy cntact us.