1. How does it work ?
----No need for any control, just connect to the power supply, the mode will automatically change .

2. Is there a controller?
----NO ! Without a controller, it will automatically switch modes when connected to the power supply!!

3. Can I cut it ?
----Yes,Of course it can be cut. Every 2 lamp beads can be cut. But cut carefully!! Cutting may affect the overall aesthetics!

4. Application:
----Suitable for All 12V Motorcycle/ Cars/Scooters/Boats or other vehicles; Home decoration, Interior or exterior decoration, Car Front and rear signal lights, Decorative lights, Warning lights, etc.

5. How to Install ?
No tools required.Just connect Red to positive(+) and Black to negative(-).

6.Before installation
Pease clean the surface of the car, keep it dry and then paste it. Think about where to paste it, otherwise the second paste will affect the adhesion!!!

Specification:
* LED Quantity: 32 Leds(30CM) / 48 Leds(60CM)
* Material: Silica Gel
* Lumens: 128 LM
* Output: 0.55A * 12V
* Working Temperature: -20°to 50°
* Size: 30*1.0*0.3CM(L*W*H) / 60*1.0*0.3CM
* Protection Rate: IP65 Waterproof
* Lifetime: > 50000 hours

Feature:
* Soft rubber design, flexible,free to bend, can be fixed in concave and convex surfaces arbitrarily.
* Self-adhesive tape on the back for easy installation and removal.
* Wide range of applications, suitable for car and home decoration.
*Automatic looping work. No controller whatsoever!

Application:

* Applicable for Automobile / Bicycle / Motorcycles / Scooters and so on decoration, border or contour lighting; Suitable for external and internal.
* Can be used as: Tear-eye lights, Chassis lights, Mesh lights, Wheel lights, Door lights, Trunk lights,Tail lights,Signal lights,Warnning lights... etc..