Bundle and save! This kit includes the Microjig GR-200 + Handle Bridge Kit + Deflector/Connector.
Protect hands and prevent kickback like never before. Powerful high-friction durable grip for extreme hold.
Work with small stock safely on the table saw, router table, jointer, & band saws.
The GRR-RIPPER Handle Bridge Kit was developed to distribute even pressure to the entire surface of each Non-Slip Pad on your GRR-RIPPER by increasing the number of contact points when downward force is applied through the handle. The installation of the Handle Bridge will provide increased control, improved balance pressure on the work piece, and virtually eliminate the need to adjust the location of the handle.
Micro Jig's GRR-RIP BLOCK Deflector/Connector Accessory is designed to give you added protection against chip/dust deflection and loose debris when working with your table saw or router table, or when freehand routing. Note: HB-010 Handle Bridge Kit is required to use with GRR-Ripper 3D and Advanced 3D Pushblocks. The Deflector/Connector Accessory can also serve as a connecting bridge between two GRR-RIP BLOCKS, with no added accessories required.
MICROJIG GRR-RIPPER DVC-538K2 Match Fit Dovetail Clamps, Yellow/Green & Matchfit X-PAD-K4 X-Pad Accessory New 4-Piece,
KWD 24
Microjig Matchfit DV-HL1.5K6 Dovetail Hardware 1.5", 6-Piece
KWD 7
MICROJIG Matchfit MB-025-0514 Dovetail 1/4" Shank 14° X 1/2" Router Bit
KWD 10.500
MICROJIG GRR-RIPPER GR-100 3D Table Saw Pushblock, Yellow
KWD 18.500
