Introduction
Get this low-power current sensor to monitor your project every second for saving energy or protecting circuit!
This fully integrated Hall Effect-based linear STK-600/M current sensor gives precise measurement for both AC and DC currents up to 50A. The thickness of the copper conductor allows survival of the device at high over-current conditions.
The STK-600/M can output an analog voltage signal that varies linearly with sensed current. The input and output are designed as through-hole vias and slots, which allow for soldering thick electrical wires and T-shaped connectors. The polarity of the input power is clearly labeled on the board so users can conveniently solder wires or use metal alligator clips to make electrical connection.
The current sensor features enhanced heat dissipation and circuit-protection functions, which typically can be applied to scenarios such as motor control, load detection & management, aeromodelling and robot over-current detection.
Features
Gravity Interface
Compatible with T-shaped plug of aeromodelling
Capable of measuring AC and DC currents
Hall current sensor
Isolated current measurement
Low current impedance of 0.08mΩ
Low-hysteresis magnetic core
Interference-free for magnet wire, external magnetic field and geomagnetic field
Specifications
Operating Voltage: 5V
Signal Type: analog
Withstand Voltage in Measuring: 50V(AC) / 120V(DC)
Current Measurement Range: -50A to 50A
Signal Bandwidth: 120kHz
Response Time: 4.6μs
Operating Temperature: -40℃ to 125℃
Dimension: 32×42mm/1.26×1.65"

Shipping List
Gravity: Analog Current Sensor 50A (AC/DC) ×1
Gravity 3P Connector ×1