Applications The anchor is made from ZAMAC.
This anchor is designed for use in Concrete, Block, and Brick.

Environment
The anchor is designed for use in a Dry environment.

Hole Diameter/Bit Diameter
The anchor requires a 1/4" hole to be drilled in the base material (Concrete, Block, and Brick).
The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Diameter of Anchor
The diameter of the anchor is 1/4".

Minimum Embedment
The minimum anchor embedment into the concrete is 3/4".
Therefore, the anchor must be installed so
that a minimum of 3/4" of the anchor is embedded into the concrete.

Spacing between Anchors
Each anchor must be spaced a minimum distance of 2-1/2"
from each other when measured center to center.

Edge Distance
It is very important not to install the anchor any closer than 1-1/4"
from an unsupported edge of the concrete.