Mechanic In A Bottle Hydraulic Oil Fix & Stabilizer can FIX and PREVENT emulsified oils so that equipment runs and operates at maximum efficiency. It will FIX milky, contaminated hydraulic oil and improve machine performance. All oils, including new oils, are affected by water. Bound water in oil has no lubrication (stiction, loss of productivity). Dissolved water molecules (polar) actively seek other polar molecules, including metals, additives such as detergents, antioxidants, friction modifiers, and anti-wear additives. Water will come out of suspension and form white gummy masses in various areas of the unit (can not be flushed). Any oil with water exceeding 300 PPM is corrosive leading to rust, hydrolysis, sludge. Emulsified water can cause oil to behave unexpectedly, and can cause clogged filters, and increased oil acidity. Hydraulic Oil Fix works in all oils including HYDRAULIC, ENGINE (CONVENTIONAL, SYNTHETIC), GEAR, TRANSMISSION, POWER STEERING, TRANSFER CASE, TURBINE, COMPRESSOR, DIFFERENTIAL, MORE. DOES NOT CONTAIN HARMFUL PETROLEUM DISTILLATES, ALCOHOL OR GLYCOL ETHERS INSTRUCTIONS: SHAKE WELL, STORE ABOVE FREEZING. FIRST DETERMINE TOTAL SYSTEM OIL CAPACITY* (INCLUDING TANK, HOSES, PUMPS, RAMS, VALVES, ETC.) For example, in a 20-gallon (2560 ounces) system, if adding 3% of OIL FIX to total system capacity, you would add 76 ounces of OIL FIX. AT ANY TIME, DO NOT LET THE AMOUNT IN THE ENTIRE SYSTEM EXCEED 3% IMPORTANT! BEFORE ADDING, RUN EQUIPMENT UNTIL ENTIRE HYDRAULIC SYSTEM OIL REACHES OPERATING TEMPERATURE. ONCE OIL FIX IS ADDED, KEEP RUNNING OR OPERATE EQUIPMENT FOR APPROXIMATELY 1 HOUR TO ENSURE OIL FIX THOROUGHLY MIXES WITH ALL OIL WITHIN THE ENTIRE SYSTEM. TO EXTEND THE LIFE OF CLEAN OIL & HELP PREVENT FUTURE PROBLEMS: ADD 1% of OIL FIX of the total system capacity. IF MILKY / EMULSIFIED OIL IS DETECTED: DRAIN SYSTEM AND ADD FRESH OIL: Then, ADD 3% of OIL FIX of the total system capacity.