Specification:
Material: ABS
Power: 36W AC 100 - 240V, 50 / 60Hz
Product Size: 16.50 x 16.50 x 10.30 cm / 6.5 x 6.5 x 4.06 inches
Plug Type: US Plug Note:
Please allow 1-3cm (0.4-1.18") difference due to manual measurement and slight color variation for different display setting.
Package Includes:
1 x Nail Gel Remover
1 x Power Cable
1 x Manual
How to use the armor remover:
3 tools: nail remover, nail file, peeling spatula.
Step 1: Use a nail file to gently rub the nail polish on the surface.
Step 2: Open the cover of the nail remover.
Step 3: Turn counterclockwise to open.
Step 4: Take out the plastic cup and add nail remover water (about 5ML).
Step 5: Put the cup containing the nail polish remover into the machine.
Step 6: Install and tighten the sealing cap, and tighten and close the cap clockwise.
Step 7: Connect the power and turn on the switch (indicator H is on)
Step 8: When the indicator light jumps to S (approximately 2 minutes after power on), open the lid, put your hands in and start to remove the armor.
Step 9: Take it out 10 minutes after removing the nails (the normal nail polish is OK for 5 minutes at the fastest) and disconnect the power in time.
Step 10:Use a peeling spatula to remove swollen nail polish.
Note: The hands must be placed correctly when removing the nails, the nails must enter the sealing ring, and all of them must be entered.The machine is temperature-protected. When it reaches a certain temperature,the lamp will be adjusted to "W" to keep it, and then it will continue to heat after the temperature drops.
1: Some nails are not inside the machine and the steam cannot be covered to achieve the effect of nail removal.
2: Your hand reaches too long and you will encounter liquid nail polish remover.