Spec:
Item Type: 3D Printer Motherboard Kit
Material: PCB
Main Board Parameters:
Model: for MKSDLC32
Voltage: 12-24V DC (MCU: ESP32 WROOM 32U (32 Bit)
MCU Frequency: 240MHz
Flash Memory: 8192K Bytes
Memory: 520K Bytes
Laser Speed: ＜8000mm/min
Offline Display: for MKS TS24 R, TS35 R
Firmware: for GRBL
Serial Port Driver: USB
Axes WIFI Onboard: 4(X, Y1, Y2, Z)
Storage Card: Support
MKS Laser Tool: Support
Available Machine: CNC Laser Engraving Machine
Stepper Driver: A4988, DRV8825, TMC2208, 2209, 2225(for Nema17 Motor)
Additional Driver: TB6600, TMC2160(for Nema23 motor)
Laser: Less Than 20W (>20W, External Power Supply)
Compatible Software: for LaserGrbl, for Xloader, for GrblController, for Benbox, for MDraw, for LightBurn
Display Parameters:
Model: TS24 R V2.1
External Size: Approx. 80 x 50mm/3.15 x 1.97in
Color Touch Screen: 2.4 Inch Touch Screen
Microprocessor: 32 Bit STM32 Processor
Update Method: SD File Update
Support Storage System: Storage Card
Support File Format: Gcode
Expandable Modules: WIFI Module, Power Failure Relay Module, Material Break Detection Switches, External Card Slot.
A4988 Driver Features And Advantages:
Low RDS (On) Output
Automatic Current Decay Mode Detection or Selection
Mixed With Slow Current Decay Mode
Synchronous Rectification For Low Power Consumption
Internal Under Voltage Lockout
Cross Current Protection
3.3 And 5 V Compatible Logic Supplies
Thermal Shut Down Circuitry
Ground Fault Protection
Load Short Circuit Protection
Five Selectable Stepping Modes: Full Step, 1/2, 1/4, 1/8, and 1/16

How to Use:
According to the introduction of using.

Package List:
1 x for MKS DLC32 V2.1 Motherboard
1 x Blue USB Data Cable
1 x TS24 R V2.1 Display Screen
2 x 10pin 40cm Row Cable
3 x Driver
3 x Heatsink