BIGTREETECH Direct BLTouch V3.1 Auto Bed Leveling Sensor+1.5m Extension Cable for Ender 3 Ender 5 Series 3D Printer with SKS Mini E3,Octopus

⚡【Warm Notice】: An additional power supply may be needed in case your board does not supply enough current at 5V.Electronic devices can be damaged or even destroyed if connected to the wrong side polarity.Set Zmin pull-up on your firmware when using Logic Free (In most cases, it is already set up)
⚡【 Smart bltouch V3.1 Highlights】: Bltouch v3.1 support logic Voltage Free(Open Drain Output),3.3V / 5V The desired output logic voltage is stored in the EEPROM of the probe and can be selected by commands.
⚡【Z trigger with adaptable width】: Z trigger with adaptable width: bltouch auto bed leveling sensor the Z trigger pulse with adaptable width beyond 10ms eliminates the danger of firmware missing the trigger and the nozzle reaching the bed.he stroke is up to 1.6mm longer than V2.0.
⚡【Engineering plastic Push-pin】: BL touch V3.1 adopts engineering plastic push-pin can be bent more easily than aluminum pins so that engineering plastic push-pin can be recovered well and the 3D printer can be protected.
⚡【Packing List】 : Included in the package are BLTouch V3.1 auto bed leveling sensor and 1.5m Extension Cable. (Notice: Please check if the wire sequence of the extension cable is consistent with that of the motherboard before using the extension cable. If not, you need to modify the wiring sequence of the extension cable according to your motherboard.)

Hello,