Restores operating surfaces of parts and compensates their current wear
Decreases steering force
Eliminates pump howl caused by wear
Increase pumping capacity
Decrease noise and vibration of the hydraulic system pump
Improves lubricating properties of hydraulic fluid and tribilogical characteristics of couplongs
Increase operating precision of the hydraulic steering booster within 30-60 miles after application
Protects parts against wear by low level of hydraulic fluid
Application
Introduce the content of the syringe* into the fluid, which is warmed up to the operating temperature, in the tank of a power steering booster. Start the engine and provide its idle operation during 2-3 minutes. Then turn the steering wheel during 5 minutes with the engine turned on. Drive a car as you normally do. The treatment is considered complete after the mechanism has been in operation for 50 hours or after 950 miles of run.

*1. The temperature of the compound before application should not be lower than +20…+25 0C.

2. It is recommended to preliminary dissolve the content of the syringe in a small amount (about 50ml) of used hydraulic fluid.

3. If the fluid in the tank of a power steering pump is contaminated (opaque or changed its initial color etc.) it's recommended to change hydraulic fluid before application.

Dosage
30 ml of the product is enough for hydraulic system with capacity of 3-5 l. If hydraulic fluid exceeds 5 liters dosage should be increased at the rate of 30 ml for every 5 l of oil.