The SafeBloc comes spliced onto a 3/4-inch Tenex from Samson. Tenex-TEC is a high-strength, low-stretch rope specifically designed allow higher production splicing for standard slings and Whoopie Slings. This construction also allows more rope surface conformance to objects being lifted than standard single braid constructions. Samthane coated to enhance its wear life. SafeBloc is a triple hole thimble that adds friction in the rigging system to the top of the tree, thus adding safety by reducing rigging point stress, compared to a system that uses a block or pulley. Also, with the benefit of friction, the climber can often take over on the rigging line AFTER the groundperson controlled the initial drop. This is true on small-to-medium loads. This frees up the groundperson to use both hands and the climber can FINISH the lowering. Use the SafeBloc anywhere you'd use an arborist block for lowering. The rigging line can be woven through the three holes for its maximum friction, or fewer holes for less friction. However, the climber should not have to travel back to the SafeBloc to do any adjustments; just pick the friction level predicted and continue to use it. The SafeBloc does NOT add significant friction. A device that added too much friction could be dangerous and fatigue the short length of rope between the SafeBloc and the material being lowered. You can use the SafeBloc without a basal lowering device on small-to-medium loads, but once you get to medium-and-above size loads, it's time to add the basal lowering device. Lightweight and durable, the SafeBloc has no moving parts to wear out or damage, and is MIL-A-8625 Type 3 hard-coated for extended wear.