Moclever Electric Fence for Dogs Underground Dog Fence w/9 Adjustable Levels 2 Recivers IPX8 Waterproof Rechargeable Pet Containment System 1.77 Acre Signal Field Range for Small Medium Large Dog
GREAT ELECTRIC FENCE: The transmitter, receiver and boundary wire forms an effective fencing system together to deter our dogs from the designated area, which greatly ensures our pets'safety. The boundary wire creates an effective signal field when the transmitter is working. If your dog tends to walk out of the boundary, the transmitter will emit a harmless radio signal
KEEPS MY PUP SAFE: The receiver works automatically once you start up the system. If your dog walks out of the boundary, the preset correction signals will be delivered cycle by cycle until the receiver battery is out of power. Mode 1: Beep+Vibration; Mode 2:Beep+Low Level Shock; Mode 3: Beep+High Level Shock. We also offer 20 training flags for you carry out proper training to ensure that the dog understands the boundaries and responds appropriately to the correction signals
MY PUP NO LONGER JUMPS THE FENCE!: One transmitter can pair with multiple receivers. The transmitter also comes with 1.77 acre signal field range and 9 adjustable levels. The signal width can be increased 0.5m/1.6ft per level from boundary wire to warning zone and from boundary wire to static correction zone. The wire break warning can tell you in time if the wire is broken. The “OK” indicator tells if the loop is right
WONDERFUL CONTAINMENT: Electric dog fence, with the 320mAh inbuilt rechargeable battery, our receiver keeps standby for 3-7 days after fully charged for 1.5-2 hours. Featured with IPX8 waterproof level, our receiver greatly extends its service life and allows your dog to play in wet grass or rainy weather. In addition, the receiver collar is 24.21in long, which can be adjusted to fit your dog's neck properly. Fit for dog of all sizes
EASY TO TEST & USE: Easy to test. First, pull out 50ft boundary wire and strip off the insulating layer of both ends. Second, make an enclosed loop with the wire and insert both ends into the terminals on the transmitter. Third, install 2 metal probes on the bottom of the receiver, and put the test bulb on. Fourth, turn on the transmitter after inserting the power cord. Fifth, hold the receiver close to the boundary wire and observe