Our 12-1/2 inch Manual Label Dispenser offers both convenience and versatility. The table/wall mount shipping label holder / sticker roll holder can either mount on a wall or be secured to a tabletop with either the pre-drilled holes or the suction cups that come with the sticker roll dispenser. Compatible with many label shapes, the separator bar removes the backing as the label is dispensed, making the label ready to affix instantly.

FOR WALL MOUNTING:
Use the pre-drilled holes, mark the wall where the screws and/or anchors* need to go (hardware not included), drill holes for anchors* (if needed), install anchors* (if needed) and thread screws into anchors or wall leaving a small gap between wall and screw head to allow dispenser to slide on. Attach dispenser and tighten screws as necessary.
* Anchors are recommended if mounting to drywall.
FOR TABLETOP MOUNTING:
There are plastic feet on the bottom that allow you to place on a tabletop without any other mounting. Depending on your use the dispenser may slide around. If you need more stability, the plastic feet can be easily removed by pulling them out which then allows the suction cups to be used. It is highly recommended that a smooth tabletop be used with the suction cups.

TO USE FOR LABELS/STICKERS:
a. mount labels/stickers directly on the spindle or if needed they can be placed on the 3” cores and then placed on the spindle.
b. pass the labels/stickers under the 2 top rollers
c. labels/stickers should feed across the top of the spiral wound bar with the backer/liner being fed underneath the spiral wound bar.
d. pull the backer that is feeding under the spiral wound bar to advance the labels/stickers as needed.