Perfect machine to make grass flocking for plantings models, landscape models, construction models.Specially design for flocking in small area, sand table construction model, and other DIY scenes.
Using Steps:
1. Put half bottle grass flocking.(NOTE:It has been suggested that the length of the grass powder is more than 5 mm, which is more effective.)
2. Put the high-voltage wire hanging on the bottle mouth so that it connects with the wire netting and thus in an energization state. Then tighten the lid.
3. Apply glue evenly to the surfaces to be flocked on the target model and table.
4. Press the operation button and wave up and down. Touch the target surface of the platform with the negative electrical connector as close as possible, then use the flocking machine to start spraying the grass powder 2-3 cm away from the platform target.
5. After the grass dust is completed, pour the grass powder or powder supplement and blot it with a vacuum cleaner model.
6. Cut the haystack with small scissors and a toothpick until it grows evenly.

Note:
Do not use the negative terminal to contact them with the wire mesh, there is a danger caused by sparks!
Use limit of less than 16 years old!
Remove the battery and place it high when not in use.
Powered by 2 * AA battery, you should prepare it by your self.
Specifications:
Name: Static Grass Flocking Applicator Set
Material: ABS
Battery: 2 * AA battery (excluded)
Rated working voltage: DC 3V
Rated working power: 0.15W
Rated output voltage: ≥DC3000V
Rated working current: 50mA
Package size: 320 * 120 * 120mm / 12.60 * 4.72 * 4.72in
Package weight: 245g / 8.64ounce
Package list:
1 * Brush
1 * Static Grass
1 * Static Grass Applicator
1 * Guideline