About Oil Suction Pump:

Rated Voltage: DC 12V
Rated Power: 60W
Maximum Pressure: 0.8Mpa
The Largest Flow: 5L/min

An Ideal for 12v Fluid Transfer Pump:
Widely used in general industrial equipment;
Small size, easy to carry and store;
Conveying low-concentration liquids, it is an ideal conversion pump for quick and clean oil changes;
Its working principle is to connect the clip to the 12V car battery, simple on/off switch power, 12v oil pump easy to use

12v Oil Pump Extractor Kit Package Included:
1 * 12v oil extractor pump
1 * 0.3" outlet pipe(inner diameter)
1 * 0.21" inlet pipe(inner diameter)
1 * 0.17" inlet pipe(inner diameter)
2 * clip
(Please allow slight error within reasonable range due to manual measurement)

Fluid Transfer Pump Kit, How to Use:
1. Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start pumping oil
2. Connect the pump to the power, run it for a while, and observe whether the inlet and outlet is normal
3. Open the filler cap, get dipstick out, force the tube into the bottom of the joint, until the tube does not move; then put the inlet pipe from the oil dipstick into in end (the tube into the bottom of the tank, the bottom concave place, in order to pump the oil completely); as no oil or pumping up very slowly or intermittently, it is generally caused by loose pipes and fittings. You have to install the pipes and fittings again.)
4. After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean, or pump water for a while until the pump head gets clean
5. If you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all out