Condition: 100% new
Color: Black
Material: Stainless
Size: approx. 16.5 x 3.8 cm(6.5 x 1.5 inch) (LxW)
Placement on Vehicle: Exterior, Rear
Item included: 1 x Third Brake Light Cover
Compatible With: compatible for Jeep Wrangler JK 2007-2017

This Is Aftermarket Replacement Item But Not Genuine

Note:
1) All dimensions are measured by hand, there may be small deviations.

2) Color may vary slightly due to the color setting of each individual monitor.

Feature:

1) According to the original factory specifications.

2) Perfect match for the original one.

3) Easy installation.

4)Full polished Stainless construction that helps stability and strength when mounted.

5) High quality powder coat that resists rust and dirt.

6) Help to protect Taillights while also providing an Off-Road Look.

7) Directly over your existing taillights allowing plenty of light to shine through. Give the rear vehicles eye-catching USA mark brake lights with when you touch the brake pedal.

Installation:

1) Pls use alcohol or agent to clean the position of the installation (to make sure it without the grease.Wax or dust etc).

2) Pls ensure the position of installation can be completely fit the case before install.

3) Rive the strong double-sided adhesive of the back, if meet the case of a relatively low temperature, please heating it via the hair dryer.

4) According to the comparison stick up it and press about 1-2 minutes (Note:do not wash your car in 24 hours, the adhesive should be fixed after 24 hours ).

5) The installation has been completed.