USB Type C PD Voltage Trigger Test Module 9V 12V 20V Adjustable 5A 100W E-MarkDescription:Supports up to 5A / 100W.Has the e-Mark chip necessary to unlock 5A output on 100W power suppliesTrigger 5V, 9V, 12V, 15V, or 20V output (not all USB-C power supplies support all voltages).The module just performs the PD negotiation and passes the outputLED voltage indicators.Retains setting after power lossPower supply must be connected to the male end of the moduleInstructions:USB-C power supply must support the PD protocolBasic operation: Connect the module to USB-C PD power supply. The LED indicates the current voltage. If no LED is illuminated then it is currently at 5V. While holding S+ press S- to unlock the board. Press S+ to increase voltage. Press S- to decrease voltage.Reset to 5V: Press and hold the S- button while connecting the module to the power supplyQuick key unlock: After powering on, while holding S+, quick press S-Quick key lock: After powering on, while holding S-, quick press S+Permanent Key Lock: Press and hold the S+ button while connecting the module to the power supply. Press S+ or S- to enable or disable the key lock. If the key lock is enabled, then the voltage cannot be changed until it is unlocked.Test Mode: Press and hold S- and S+ simultaneously while connecting the module to the power supply. The output voltage will automatically cycle between all supported voltages.Note:Manual measurement, with small error. Please check size in detail before purchase.Real colors may slightly differ from the pictures, as it depends on specific monitor settings and light brightness.Package Includes:1 × USB Type C PD Voltage Trigger Test Module 9V 12V 20V Adjustable 5A 100W E-Mark