Invisibly mount wall panels, cabinets, mirrors, picture frames, bed headboard, or anything else to a vertical surface !

Installation Tips
- Each set has about 1/16" of lateral play. This makes them fairly forgiving, but try to be as precise as possible when laying things out.
- Attach to wall first. The hole spacing is 8/ 5", so be sure to find the exact center of the stud and put the 1-3/4" screws in at a slight angle to ensure it get a good bite into the wood.
- Measure out and secure clips to the object you're hanging, just using two 3/4” screws in each clip at first.
- Hang the object. If no tweaks needed, install the remaining screws.
- The clips have a finished thickness of 1/ 5". That's fine for most applications, but if you're handy in the workshop and are able to route a recess in the back of the wood item you want to hang, a completely flush look can be achieved.

Specifcation
1 Set include: 2- Z Clips (Large), 4- short screws, 4- long screws.
You get: 2 sets

Z-Clip: Cold rolled stainless steel
Dimension - 54mm x 30mm
Thickness - 2mm
Hole diameter - 5mm
Hole spacing - 40mm

Short screw: Steel cross sink screw
Diameter - 4mm
Length - 20mm

Long screw: Steel cross sink screw
Diameter - 4mm
Length - 45mm